I snagged another DC-8 and I tried adding it (daisy chaining it) and my AC III doesn't see it. I've got it plugged into the right ports (control out) on the 1st DC 8 and below are my jumper settings on the 2nd DC-8 as well as my program. After all this, the AC III doesn't see the second DC-8. I unplugged it, did a self test, etc.
I swapped out the control (phone) cords between the two and both cords work. Some of the plugs on the second DC8 are on, but some aren't. Either way, the AC III doesn't see the second DC-8. Any ideas?
jumpers on second DC-8:
1 = on
2 = off
3 = on
4 = off
(According to the manual, this should make the second DC-8 bank ()
Program: (I haven't added in any statements for bank B yet as I can't get the ACIII to even see it)
If Time > 09:30 Then ACT ON
If Time > 21:30 Then ACT OFF
If Time > 13:30 Then ML1 ON
If Time > 20:00 Then ML1 OFF
If Time > 13:45 Then ML2 ON
If Time > 20:15 Then ML2 OFF
If Timer ML1 = ON Then FN1 ON
If Timer ML2 = ON Then FN1 ON
If Time > 13:30 Then FN1 ON
If Time > 20:15 Then FN1 OFF
If Time > 21:30 Then FL1 ON
If Time > 09:30 Then FL1 OFF
If Temp > 77.6 Then FN2 ON
If Temp = 77.5 Then FN2 OFF
If Temp < 77.5 Then FN2 OFF
If Temp > 81.5 Then ML1 OFF
If Temp > 81.5 Then ML2 OFF
If Temp < 77.3 Then HT1 ON
If Temp = 77.3 Then HT1 ON
If Temp > 77.3 Then HT1 OFF
OSC 001/001 ON/OFF Then PM1 ON