Myvirtue Posted September 11, 2012 Share Posted September 11, 2012 I have blue as my back wall and i want to remove it and paint it black. is there any chemicals i can use without harming the tank. its on the exterior. scraping isnt working that well. Link to comment Share on other sites More sharing options...
victoly Posted September 11, 2012 Share Posted September 11, 2012 paint thinner, mineral spirits, goof off are good places to start. When complete, make sure you give it a good wipe with isopropyl alchohol or you may have trouble getting the new paint to bind to the surface. I like to rough it up a bit as well with some fine grit sandpaper. Link to comment Share on other sites More sharing options...
ClarkiiCircus Posted September 11, 2012 Share Posted September 11, 2012 Like the exterior as like water inside the tank will not touch the newly painted exterior? If the tank is glass and the black paint is oil-based, any weak solvent (mineral spirits/ acetone) on a rag should take it right off...Let in set in the sun and wind for a few hours to remove the smell. Link to comment Share on other sites More sharing options...
Myvirtue Posted September 11, 2012 Author Share Posted September 11, 2012 yah i cant move the tank outside. i just barely managed moving it 6 inches to get behind it. its up and running. water wont touch it. exterior back glass. thanks for the tips Link to comment Share on other sites More sharing options...
wesreyn Posted September 11, 2012 Share Posted September 11, 2012 It won't scrape with a razor blade? That's what I've always used with good success. Link to comment Share on other sites More sharing options...
offroadodge Posted September 11, 2012 Share Posted September 11, 2012 It won't scrape with a razor blade? That's what I've always used with good success. +1 thats what i would do. Link to comment Share on other sites More sharing options...
Timfish Posted September 12, 2012 Share Posted September 12, 2012 Is it possible to slide a piece of thin black acrylic behind the rock work? I had to to that once. I needed to split it into two pieces but was able to hide it with the rockwork. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.