lemonyx

I'm starting my 200gal build and starting with the sump first. I will show you how I do it and most of the tank builders do it. The sump is about a 79gal measures 49 3/4"L x 24"W x 16"H. I used oversize sheet of 3/8" Plex "G" which is 50"x99", great for those who have to have a 24" deep tank (inside dimensions) On with the build. The plans, gotta have a map of what you want, where it's gonna go and if it'll fit or not. I didn't take any pix's of the cutting as I have my wholesaler do that. But the routing is the next step My router table, I have a total of 3 leafs if i need the room for those longer tanks The working end What's left after routing, a big mess that sticks to everything. Too bad I can't melt this and make a sheet of plastic The ends pieces The baffles The front and back and top and bottom pieces The filter Sock Holder The tools:

I'd do it if I were closer. All you need is 12ga 3wire (wire) to extend your current plug. HD/Lowes has it in the electrical wire section, it's thick and yellow (when I bought mine) and just need a 220v male plug. You can DI, just follow where the current wire goes to, 2 hots and one common/gnd and wire up the new cord the same and make sure the plug is wired the same the 2 hots and the other common/gnd

Just 2 baffles as muddyblue said. I have 3 in my sump and over, then under, then over again and have noticed that bubbles will not go under the 2nd baffle and instead get pulled down about an inch and then float up and burst after the first.

Well, you could diy Lumenarcs and I made my own hanging pendent. I used this for the material (makes 2) this pattern (see below) As mentioned, there is just enough room for the Lumenarcs and in mine I have 2x actinics on either side - stuffed in.

Looks really nice - on my list too

Those are some really nice corals and great prices, too bad I wasn't closer

I know this was back in May, but would you still have Frag Pack #3 $170 for sale? LMK