Jump to content

PH controller ?s


offroadodge

Recommended Posts

ok, im getting ready to set up my calcium reactor and wanted to ask some questions. The PH controller i have now turns on the switched power when the PH goes above the set point, so say i set it at 6.85, once the PH reaches this point and goes above, it turns the switch on then turning the relay on the CO2 tank on and releases CO2 until it goes back down below set value. Is this the correct operation? Im VERY new to the calcium reactor thing so any help would be appreciated. Sometimes i do better talking to someone on the phone rather than the computer but anything will work. Thanks before hand!

Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.

×
×
  • Create New...