Fireman cole Posted September 22, 2016 Share Posted September 22, 2016 I got a new AI prime hd i was runing and t5 light how do i make the switch and what do intensity do i set it and how hight off the water what colors at what % Link to comment Share on other sites More sharing options...
Neon Reefer Posted September 23, 2016 Share Posted September 23, 2016 Here is sa link to a discussion on your very questions. A simple google inquiry will bring up lots of info http://www.nano-reef.com/topic/359838-ai-prime-settings-informational-only-please-no-discussion/ Link to comment Share on other sites More sharing options...
Neon Reefer Posted September 23, 2016 Share Posted September 23, 2016 Oh and FYI when you switch from T5 to LED expect some bleaching of corals as they expel their zooxanthellae algae to take on another that better utilizes the LED spectrum. Many will confuse this with bleaching caused by light intensity. As long as you have good polyp extension your OK. I would start at 15K mix for spectrum and ~ 50% intensity and This light has optics of 80 degrees therefore it will covert a 36" x 36" inch area at a height of 24 inches over open air. Link to comment Share on other sites More sharing options...
Fireman cole Posted September 24, 2016 Author Share Posted September 24, 2016 Thank you for your help i found a lot of helpful info Link to comment Share on other sites More sharing options...
+FluxCapacitor Posted September 24, 2016 Share Posted September 24, 2016 I don't adjust my Prime by messing w/ the lights individually on it. I hit the little circular button up in the right hand corner and adjust the kelvin rating and intensity that way. Might help you out. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.