Jason & Amber Posted December 22, 2013 Share Posted December 22, 2013 So I set up my probes last night and today my PH was at 10.3 on my apex I tested it on my test kit and it was I would say 8.6 or 8.7 but that is also the max. I had been dosing alk was at 8.3 now at 9.5. I read I can add vinegar to bring my PH down but how much should I add I have about 200 gallon system volume? Also do y'all usually have the temp compensation turned on on your apex? What else can I try to bring the PH down? Sent from my iPad using Tapatalk Link to comment Share on other sites More sharing options...
victoly Posted December 22, 2013 Share Posted December 22, 2013 Calibrate your probes before you take corrective action. Link to comment Share on other sites More sharing options...
Jason & Amber Posted December 22, 2013 Author Share Posted December 22, 2013 Thanks for the fast response, I calibrated them last night before in stalling them. Is there a way I can verify my calibration, Maybe stick it into the 10.0 solution and see what it shows? Sent from my iPad using Tapatalk Link to comment Share on other sites More sharing options...
haze152 Posted December 23, 2013 Share Posted December 23, 2013 Can verify by sticking probe in a solution of your choice just make sure it is new solution Link to comment Share on other sites More sharing options...
Jason & Amber Posted December 23, 2013 Author Share Posted December 23, 2013 We'll stuck in 10.0 solution and showed 11.5 recalibrated now shows 7.75. Sent from my iPad using Tapatalk Link to comment Share on other sites More sharing options...
victoly Posted December 23, 2013 Share Posted December 23, 2013 There ya go Link to comment Share on other sites More sharing options...
victoly Posted December 23, 2013 Share Posted December 23, 2013 and for reference, temperature correction IS important. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.