Jimbo662 Posted May 30, 2016 Share Posted May 30, 2016 I've googled but can't find this exact issue. I power it up (no apex connected) it's red for about a second, changes to white, fades to blue and starts running. it only stays blue for a second then starts flashing white. The prop runs slow. This last stage lasts for a couple of minutes the all goes dark. The only thing I can find on a white blink is that it indicates feed mode. I initially thought it was stalling so I soaked in water / vinegar but i get the same results after that. Any ideas? Link to comment Share on other sites More sharing options...
bige Posted May 30, 2016 Share Posted May 30, 2016 You could try factory reset. I had one do something similar and the reset fixed it. Link to comment Share on other sites More sharing options...
Jimbo662 Posted May 30, 2016 Author Share Posted May 30, 2016 Once I got the apex running again it started working! Link to comment Share on other sites More sharing options...
Juiceman Posted May 31, 2016 Share Posted May 31, 2016 haha, good ole Vortech troubleshooting... been there! Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.