jestep Posted September 23, 2013 Share Posted September 23, 2013 Any woodworkers around here that can skin a steel stand? I'm pretty decent with carpentry, but I was looking at the plywood at Lowes and HD and they all suck. Warped and based on my past experience their cuts are really rough. I have a table saw with a good blade but am less than thrilled about cutting full size plywood sheets. Last time I did full sheets mine looked worse than lowes. I'm not looking for anything especially fancy. Need to skin 3 sides of a 48 x 18 stand - 4 pieces total. Would like oak ply, possibly with trim, still trying to picture that. Otherwise just ply with routed edges. Link to comment Share on other sites More sharing options...
joselo Posted September 23, 2013 Share Posted September 23, 2013 Don't want to steal your thread but i am also looking for someone who can do this. Link to comment Share on other sites More sharing options...
jestep Posted September 23, 2013 Author Share Posted September 23, 2013 Don't want to steal your thread but i am also looking for someone who can do this. No problem. I'm sure there's someone here that can do them. Link to comment Share on other sites More sharing options...
ct67stang Posted September 24, 2013 Share Posted September 24, 2013 I can do that Link to comment Share on other sites More sharing options...
mFrame Posted September 24, 2013 Share Posted September 24, 2013 There are two local sources I'd point you to for high quality lumber, Fine Lumber & Plywood is North and Brazos Forest Products down south. The both may be able to provide the precision cuts you need and then you would just have to pick up the material. Link to comment Share on other sites More sharing options...
dsquared Posted September 25, 2013 Share Posted September 25, 2013 +1 for Brazos Forest Products. They have great prices. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.