ceastman Posted February 11, 2016 Share Posted February 11, 2016 so any secret on getting one of those 1/4" water lines to stay connected to an ato metering pump? Link to comment Share on other sites More sharing options...
FarmerTy Posted February 11, 2016 Share Posted February 11, 2016 What are you trying to do exactly? The pump showed is meant to be put in your ATO reservoir. Are you trying to connect it directly to the RO line coming out of your RO/DI system? Link to comment Share on other sites More sharing options...
Gig 'em @ NDstructible Posted February 11, 2016 Share Posted February 11, 2016 I agree with Ty on determining what exactly you are trying to accomplish first. However, the top looks a lot like a pump I use in environmental sampling and this is a picture of how I connect 1/4 tubing to a larger connection by using different sizes of tubing to step down Sent from my iPhone using Tapatalk Link to comment Share on other sites More sharing options...
Juiceman Posted February 11, 2016 Share Posted February 11, 2016 The Black tubing that comes with it should just fit in very snug. I don't have an issues with it coming out. Does it not stay in? Link to comment Share on other sites More sharing options...
ceastman Posted February 11, 2016 Author Share Posted February 11, 2016 I have these pumps in my rodi reservoir bucket. so when my apex detects my sump is low it turns this pump on to add rodi water to the sump. gig'em yep that looks like what I got, just my tubing has popped out. I have another pump but I was able to find a small plastic insert that I put into the tubbing that was hollow but it expanded the tubing a bit so it doesn't pop off the pump when then pump turns on. Link to comment Share on other sites More sharing options...
jestep Posted February 11, 2016 Share Posted February 11, 2016 If you're not using the stock tubing which fits fairly snugly, you might try dipping the tubing in some boiling water for a few seconds and stretch it over the entire outlet piece. Assuming you're using vinyl or silicon tubing and not something rigid like RO tubing. Link to comment Share on other sites More sharing options...
ceastman Posted February 11, 2016 Author Share Posted February 11, 2016 I didn't get any tubing with the replacement pump, just the pump and the electrical connection. Link to comment Share on other sites More sharing options...
FarmerTy Posted February 11, 2016 Share Posted February 11, 2016 Tunze is located in town. I'd just give them a call and they'll probably just give you the tubing or pieces needed to make it fit. Link to comment Share on other sites More sharing options...
Juiceman Posted February 11, 2016 Share Posted February 11, 2016 Tunze is located in town. I'd just give them a call and they'll probably just give you the tubing or pieces needed to make it fit. Yeah they'll probably just give it to you. They've always been very helpful with me. Link to comment Share on other sites More sharing options...
ceastman Posted February 11, 2016 Author Share Posted February 11, 2016 oh yeah that's right they are close by. thanks for reminding me. Link to comment Share on other sites More sharing options...
victoly Posted February 11, 2016 Share Posted February 11, 2016 i think a 1/2 john guest fits on the hard plastic. if you get a 0.5 to .25 reducer you can use plain old poly 0.25" on it Link to comment Share on other sites More sharing options...
Reburn Posted February 12, 2016 Share Posted February 12, 2016 1/4 John guest fits in the inside fine. Just remove the little sleeve and push it in. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.